Wire connection: conduit – LG LRE3025ST User Manual

Page 10

Advertising
background image

10

ELECTRICAL CONNECTIONS

4-WIRE CONNECTION: CONDUIT

1. Follow the instructions under “Install the conduit as

follows” on page 8 to correctly install the strain relief.
DO NOT install the conduit without a strain relief.

2. Loosen the 2 lower left and right screws from the

terminal block. (Refer to Figure 12.) Remove the lower
2 center screws.

3. Remove ground strap and discard as shown in Figure

12. Do not discard any screws.

4. Attach the ground bare wire end to range frame and

secure it in place with the ground screw (Refer to
figure 12.)

5. Insert the bare wire (white/neutral) end through the

center terminal block opening.

6. Insert the two side bare wire ends into the left and the

right terminal block opening. Tighten the 3 screws
securely into the terminal block. (approximately
35 - 50 IN-LB)

7. Refer to page 11.

4-wire connection

Remove

ground

strap and

discard

Terminal

block

Wire

ends

Conduit

connection plate

Black White Red

Ground

strap

Ground

Wire

Ground

Screw

FIgURE 12

Advertising
This manual is related to the following products: