Wire connection with a power supply cord, Warning, Install the power cord as follows – LG LRE3025ST User Manual

Page 8

Advertising
background image

8

ELECTRICAL CONNECTIONS

3-WIRE CONNECTION WITH

A POWER SUPPLY CORD

• The middle (neutral or ground) wire of a 3

wire power cord or a 3 wire conduit has to
be connected to the middle post of the main
terminal block. The remaining two wires of the
power cord or conduit have to be connected
to the outside posts of the main terminal
connection block.

- Failure to do so can result in electrical shock,

severe personal injury or death.

WARNING

Install the power cord as follows:

For power cord installations, Hook the strain relief over
the power cord hole (1

3

/

8

”) located below the rear of

lower oven. Insert the power cord through the strain
relief and tighten it. (Refer to Figure 7.)

DO NOT install the power cord without a strain relief.

1. Remove the lower 3 screws from the terminal block

and retain them. (Refer to Figure 8.)

2. Insert the 3 screws through each power cord terminal

ring and into the lower terminals of the terminal block.
Make sure that the center wire (white/neutral) is
connected to the center lower position of the terminal
block.

3. Tighten 3 screws securely into the terminal block. Do

not remove the ground strap connections.

4. Refer to page 11.

Cord strain relief

Power cord

Conduit

connection

plate

Separate Strain Relief

before installation

Assemble the strain relief

to the 1

3

/

8

” opening in

Conduit connection plate

FIgURE 7

3-wire connection

Terminal

block

Conduit

connection plate

Black White Red

FIgURE 8

Advertising
This manual is related to the following products: