Chapter 2 installation, Requirements, Procedure – LevelOne FBR-1402TX User Manual
Page 10: Requirements procedure, Installation, Chapter 2
7
2
Chapter 2
Installation
This Chapter covers the physical installation of the LevelOne Broadband
Router.
Requirements
•
Network cables. Use standard 10/100BaseT network (UTP) cables with RJ45 connectors.
•
TCP/IP protocol must be installed on all PCs.
•
For Internet Access, an Internet Access account with an ISP, and either of a DSL or Cable
modem (for WAN port usage)
•
For shared access to the attached printer, the following clients are supported:
•
Windows 95/98/ME
•
Windows NT 4.0, 2000 or XP
•
Unix (LPD printing)
Procedure
Figure 5: Installation Diagram
1. Choose an Installation Site
Select a suitable place on the network to install the LevelOne Broadband Router.
Ensure the LevelOne Broadband Router and the DSL/Cable modem are powered OFF.
2. Connect LAN Cables
•
Use standard LAN cables to connect PCs to the Switching Hub ports on the LevelOne
Broadband Router. Both 10BaseT and 100BaseT connections can be used simultaneously.
•
If required, you can connect the "LAN1" port to another Hub: