LevelOne FBR-1402TX - Manual (Page 11)

LevelOne Broadband Router User Guide
• Depress the "Uplink" button beside the "LAN1" port.
• Use a standard LAN cable to connect the "LAN1"port to a standard port on the other
hub.
3. Connect WAN Cable
Connect the DSL or Cable modem to the WAN port on the LevelOne Broadband Router.
Use the cable supplied with your DSL/Cable modem. If no cable was supplied, use a stan-
dard cable.
4. Connect Printer Cable (FBR-1403TX only)
Use a standard parallel printer cable to connect your printer to the Printer port on the Leve-
lOne Broadband Router.
5. Power Up
• Power on the Cable or DSL modem.
• Connect the supplied power adapter to the LevelOne Broadband Router and power up.
Use only the power adapter provided. Using a different one may cause hardware damage
6. Check the LEDs
• The Power LED should be ON.
• The Status LED should flash, then turn Off. If it stays on, there is a hardware error.
• For each LAN (PC) connection, the LAN Link/Act LED should be ON (provided the PC is
also ON.)
• The WAN LED should be ON.
• For the FBR-1403TX, the Print Act LED should be ON if a printer is connected and On-
line.
For more information, refer Physical Details in Chapter 1.
8