LevelOne FBR-1416 - Manual (Page 8)

Introduction
Rear Panel
Figure 3: Rear Panel
Power port Connect the supplied power adapter here.
10/100BaseT
LAN connections Use standard LAN cables (RJ45 connectors) to connect your PCs to
these ports.
Note:
Any LAN port on the FBR-1416 will automatically function as an
"Uplink" port when required. Just connect any port to a normal port
on the other hub, using a standard LAN cable.
Reset Button
(Reset to Defaults) This button will reset the FBR-1416 to the factory default values.
To do this, press and hold the Reset Button for five (5) seconds, until
the Status LED is lit, then release the Reset Button, and wait the
FBR-1416 to restart using the factory default values.
WAN port
(ADSL port) Connect this port to your ADSL line.
5