Linksys WIP330 User Manual
Page 15
Advertising
Wireless-G IP Phone
9
Chapter 3: Installing and Using the Wireless-G IP Phone
Powering on the Wireless-G IP Phone
3. The power LED will flash, alternating between blue and purple. For the initial charge, allow the
battery to charge for at least 10 hours, so the battery will have a full charge, which is indicated by a
solidly lit Power LED. This maximizes battery performance and life.
When the battery is fully charged, proceed to “Setting up the Wireless-G IP Phone.”
Power LED
Softkey
Power On/Off
or End Call
Softkey
Navigation Pad
and Center
Selection Key
Call
Figure 3-4: Front Panel
Advertising