Lava Computer 2SP-PCI - Manual (Page 5)

4. Use the up/down arrows to scroll to one of the following range
settings, or type them in manually:
0278 – 027F 0378 – 037F
0238 – 023F 02B8 – 02BF
5. After one of these has been entered, click OK. Windows will verify
whether you would like to force this particular configuration rather
than the automatic one that it had previously chosen. Click Yes.
6. Verify that there are no conflicts with addresses being used by other
devices already in your PC. If no conflicts are found, restart Windows.
0338 – 033F
2. Remove the check mark from the Use Automatic Settings box.
Note: In some cases Windows will give an error message to the effect
that "Windows cannot modify this resource" at this point. If you are
unable to access the settings for changing system resources, reboot the
system in Safe Mode to make changes to resource settings. (To enter
Safe Mode, press the F8 key while the system is rebooting.)
3. Double-click on the words Input/Output Range. The following
screen will appear: