Lowrance electronic GlobalMap 5000C - Manual (Page 97)

91
From the Trails Menu, press
→ to
T
RAIL
O
PTIONS
| ENT . With U
PDATE
A
CTIVE
T RAIL
highlighted, press ENT to check it (turn on) and uncheck it (turn
off).
Update Trail Criteria (Auto, Time, Distance)
The options are automatic, time, or distance. When it's in the default
automatic mode, the unit doesn't update the plot trail while you're
traveling in a straight line. Once you deviate from a straight line, the
unit "drops" a plot point (trail waypoint) onto the trail. This conserves
plot trail points. If a plot trail uses all of the available points allotted to
it, the beginning points are taken away and placed at the end of the trail.
From the Trails Menu, press
→ to
T
RAIL
O
PTIONS
| ENT |
↓ to
U
PDATE
C
RITERIA
. Press ↑ or ↓ to select
criteria type|
ENT . If you selected Time,
the Update Rate data entry box appears on the menu. If you selected
Distance, the Update Distance data entry box appears on the menu.
Trail Update (Time, Distance)
You can update a trail by time, with a range from 1 second to 9999 sec-
onds; the default is 3 seconds. You can update by distance, with a range
from 0.01 mile/nm/km to 9.99 mile/nm/km; the default is 0.10 miles.
With one of the Update Criteria selected, use the cursor arrows to
highlight either the
U
PDATE
R
ATE
or U
PDATE
D
ISTANCE
data entry boxes and
press ENT . Press
↑ or ↓ to change the first character, then press → to
the next character and repeat until the entry is correct. Press EXIT to
return to the Trail Options Menu.
Trail Options menu: Update Time setting, left, and Update Distance
setting, right.
Specific Trail Options
Delete Trail
To delete a specific trail: From the Trails Menu, press
↓ to Trail
Name|
ENT . The Edit Trail menu appears as seen in the following fig-
ure. Press
→ to
D
ELETE
T
RAIL
| ENT |
← to
Y
ES
| ENT .