Lathem 7000E - Manual (Page 30)

Setting the Auto Break Deduction
30
Refer to "WHAT YOU CAN DO WITH THE 7000E" before setting.
If error " E-49 " appears when you try to change settings, then you must reset all cards
before proceeding. ( See "All cards reset" )
Example
Elapsed time ----- 8 hours Break duration ----- 60 min.
3
Push the SET button. At that moment, the
flashing changes to "Hour". In the case of
the example, push the CHANGE button to
set at "8" and then push the SET button. At
that moment, the flashing of the display
will change from "Hour" to "Minute".
1
Push the FUNCTION button for 3
seconds.
2
Push the FUNCTION button and
position the " " under the "AUTO
BREAK DEDUCTION" mark.
Order Option
Elapsed time
Break duration 1
2
SET FUNCTION CHANGE
5
Push the CHANGE button twice to set the
left-side number at "2" and then push the
SET button. At that moment, the flashing
of the display will change to "Minute".
7
Push the SET button once again.
6
In this case, push the CHANGE button to
set at "60". And then push the SET button.
Range of value: 1 - 90 min.
Set the "Break duration".
4
In this case, push the CHANGE
button to set at "00". And then push
the SET button.
Set the "Elapsed time".
AUTO BREAK
DEDUCTION
SET FUNCTION CHANGE
AUTO BREAK
DEDUCTION
SET FUNCTION CHANGE
AUTO BREAK
DEDUCTION
SET FUNCTION CHANGE
AUTO BREAK
DEDUCTION
SET FUNCTION CHANGE
AUTO BREAK
DEDUCTION
Minute
Minute
Elapsed time
setting
Break duration
setting
Hour
27