La Crosse Technology WS-9711U-IT - Manual (Page 12)

45
To wall mount:
1. Secure the bracket onto a desired wall using the screws and plastic
anchors.
2. Clip the remote temperature sensor onto the bracket.
Note:
Before permanently fixing the transmitter wall base, place all units in the
desired locations to check that the outdoor temperature reading is
receivable. In event that the signal is not received, relocate the
transmitters or move them slightly as this may help the signal reception.
POSITIONING THE WEATHER STATION:
The Weather Station comes complete with a foldout stand that gives the
option of table standing or wall mounting.
To wall mount:
1.
Fix a screw into the desired wall, leaving the head extended out
about 0.2” (5mm).
2. Using the Weather Station’s hanging hole, carefully hang it onto the
screw.
Note: Always ensures that the unit locks onto the screw head before
releasing.
46
CARE AND MAINTENANCE:
 Extreme temperatures, vibration and shock should be avoided as these may cause
damage to the unit and give inaccurate forecasts and readings.
 Precautions shall be taken when handling the batteries. Injuries, burns, or property
damage may be resulted if the batteries are in contact with conducting materials, heat,
corrosive materials or explosives. The batteries shall be taken out from the unit before
the product is to be stored for a long period of time.
 Immediately remove all low powered batteries to avoid leakage and damage. Replace
only with new batteries of the recommended type.
 When cleaning the display and casings, use a soft damp cloth only. Do not use
solvents or scouring agents as they may mark the LCD and casings.
 Do not submerge the unit in water.
 Special care shall be taken when handling a damaged LCD display. The liquid crystals
can be harmful to user's health.
 Do not make any repair attempts to the unit. Return them to their original point of
purchase for repair by a qualified engineer. Opening and tampering with the unit may
invalidate their guarantee.
 Never touch the exposed electronic circuit of the device as there is a danger of electric
shock should it becomes exposed.
 Do not expose the units to extreme and sudden temperature changes, this may lead
to rapid changes in forecasts and readings and thereby reduce their accuracy.
47
SPECIFICATIONS:
Temperature measuring range:
Indoor :
14.1°F to +139.8°F with 0.2°F resolution (-9.9ºC to +59.9ºC with 0.1ºC
resolution, “OF.L” displayed if outside this range)
Outdoor : -39.8°F to +139.8°F with 0.2°F resolution, (-39.9ºC to +59.9ºC with 0.1ºC
resolution, “OF.L” displayed if outside this range)
Relative humidity measuring range:
Indoor
: 1% to 99% with 1% resolution (displays “- -” when lower than 1 %; displays
"99" % if higher than 99 %)
Indoor temperature checking interval : every 15 seconds
Indoor humidity checking interval
: every 20 seconds
Outdoor temperature reception : every 4 seconds
Transmission range : up to 330 feet (100 meters) in open air
Power consumption:
Weather Station
: 2 x AA, IEC, LR6, 1.5V
Temperature transmitter : 2 x AA, IEC, LR6, 1.5V
Battery life cycle (Alkaline batteries recommended)
Weather station
: Approximately 24 months
Temperature transmitter : Approximately 24 months
Dimensions (H x L x D)
Weather Station
: 3.64 x 4.89 x 1.12 inches (92.5 x 124.3 x 28.4 mm)
Temperature transmitter : 5.05 x 0.83 x 1.50 inches (128.3 x 38.2 x 21.2 mm)
48
LIABILITY DISCLAIMER
 The manufacturer and supplier cannot accept any responsibility for any incorrect
readings and any consequences that occur should an inaccurate reading take place.
 This product is not to be used for medical purposes or for public information.
 This product is only designed to be used in the home as indication of the future
weather and is not 100% accurate. Weather forecasts given by this product should be
taken as an indication and not as being totally accurate.
 The specifications of this product may change without prior notice.
 This product is not a toy. Keep out of the reach of children.
 No part of this manual may be reproduced without written consent of the
manufacturer.
WARRANTY INFORMATION
La Crosse Technology ®, Ltd provides a 1-year limited warranty on this product against
manufacturing defects in materials and workmanship.
This limited warranty begins on the original date of purchase, is valid only on products
purchased and used in North America and only to the original purchaser of this product. To
receive warranty service, the purchaser must contact La Crosse Technology ®, Ltd for
problem determination and service procedures. Warranty service can only be performed by
a La Crosse Technology ®, Ltd authorized service center. The original dated bill of sale must
be presented upon request as proof of purchase to La Crosse Technology ®, Ltd or La
Crosse Technology ®, Ltd’s authorized service center.