La Crosse Technology WS-7213U - Manual (Page 24)

24
3) Once the system has been reset and you
have a temperature and humidity reading
from the sensor, temporarily place the
remote temp/humidity sensor in the
previous location.
Note: If there is a outdoor temperature and
humidity displayed when the two units are
close together there was either too much
distance between the two units previously or
some type of interference that was causing
poor reception.
4) If after 15 minutes the temperature and
humidity are not displayed you will need
to choose another location for placement
of the temp/humidity sensor.
5) The best way of doing this is to move the
sensor 10 feet closer to the indoor
weather station.
6) After moving the remote temp/humidity
sensor please wait 15 minutes to give the
indoor weather station time to re-acquire
the signal.