Lexmark Z32 - Manual (Page 37)

Ap
pen
d
ix
Appendix 33
•
•
•
•
•
Note: No diskettes are
available for use with
Macintosh.
Uninstalling printer
software for
Windows
If your printer software does not
install properly, or your printer is
not installed to the correct port,
you may need to uninstall, and
then reinstall the software.
To uninstall the printer software:
1 From the Start menu, select
Programs.
2 Select Lexmark Z22/Z32
Series.
3 Select Lexmark Z22/Z32
Series Uninstall.
4 Follow the instructions on
your screen.
To reinstall the printer software,
follow the appropriate set of
instructions from “Installing
printer software” on page 31.
Uninstalling printer
software for
Macintosh
If your printer software does not
install properly, you may need to
uninstall, and then reinstall the
software.
To uninstall the printer software:
1 Drag the printer icon to the
trash can on the desktop.
2 Insert the software CD.
The Lexmark Z22/Z32
Installer screen appears.
3 Click Install and Agree.
4 From the Easy Install pop-up
menu, choose Uninstall.
5 Select Complete Uninstall.
6 Click Uninstall.
Printing from DOS
To open your printer online Help
system and find information on
printing from DOS:
1 Open the Printer Properties
or the Control Program. For
help, see “Changing the
Printer Properties from an
application” on page 4 or
“Using the Control Program
in Windows” on page 15.
2 Click the Help button in the
lower-right corner of the
software screen.
3 At the top of the Help screen,
click Help Contents.
4 Scroll down the screen to
How to....
5 From the How to... topics,
click Print from Windows
and DOS applications.
Electronic emission
notices
Federal
Communications
Commission (FCC)
compliance information
statement
The Lexmark Z22/Z32 Color
Jetprinter has been tested and
found to comply with the limits
for a Class B digital device,
pursuant to Part 15 of the FCC
Rules. Operation is subject to
the following two conditions: (1)
this device may not cause
harmful interference, and (2) this
device must accept any
interference received, including
interference that may cause
undesired operation.
The FCC Class B limits are
designed to provide reasonable
protection against harmful
interference in a residential
installation. This equipment
generates, uses and can radiate
radio frequency energy and, if
not installed and used in
accordance with the
instructions, may cause harmful
interference to radio
communications. However, there
is no guarantee that interference
will not occur in a particular
installation. If this equipment
does cause harmful interference
to radio or television reception,
which can be determined by
turning the equipment off and
on, the user is encouraged to try
to correct the interference by
one or more of the following
measures:
• Reorient or relocate the
receiving antenna.
• Increase the separation
between the equipment and
receiver.
• Connect the equipment into
an outlet on a circuit
different from that to which
the receiver is connected.
• Consult your point of
purchase or service
representative for additional
suggestions.
The manufacturer is not
responsible for any radio or
television interference caused by
using other than recommended