Liebherr HC 20 - Manual (Page 11)

Figure 11
Mounting the anti tipping device
in cabinets deeper than 24"
-
Figure 12 - 13
1. Mark the center line of the appliance on the back
wall. Align the anti tipping bracket center to this
line.
Be sure that there is no plumbing or
electrical wiring located in this area which
screws or drills could damage.
2. Fasten bracket to the wooden floor using 5
screws (1/4" x 2-1/8"). Drill pilot holes if neces-
sary.
3. Fasten bracket with 3 screws (1/4" x 2-1/8") into
the wall plate.
Wall Plate
Wall
Mounting the anti tipping device
on wooden floors
- Figure 11
To ensure the compressor mounting plate reaches
the anti tipping bracket at cabinets deeper than
24", a wooden spacer must be mounted between
the appliance back and the wall. The anti tipping
bracket will be fastened to the floor downwards and
to the spacer backwards.
Be sure the wooden spacer is fastened
securely to the floor.
Figure 12
Measuring for mounting the wooden spacer
at frameless kitchen cabinets - Figure 13
Figure 13
Panel thickness
Depth of spacer depending on
clearence between appliance and wall.
Depth of spacer depending on
clearence between appliance and wall.
Measuring for mounting the wooden spacer
at framed kitchen cabinets - Figure 12
11
B
LOCKING
F
OR
S
AFETY