Lantronix UBox UBX4100 - Manual (Page 39)

Changing the UBox's Settings
and you move the USB device to a different port,
select the Requires Password to Connect checkbox
again.
Connection
Password and
Reenter Password If you selected the checkbox above, enter and then reenter
a password a user must use to view the USB device.
Share Mode Select one of the following types of connection:
Shared: Allows multiple computers to connect to and
disconnect from the USB device. Default.
Dedicated: Dedicates the USB device to a specific
computer.
Share modes apply to a specific UBox:
‹ If you move a USB device to another UBox, reset that
USB device's share mode on the new UBox.
‹ If your USB Device does not have a serial number,
and you move the USB device to a different port, reset
the share mode. This is only necessary if the share
mode is Dedicated.
Client Name If you selected the Requires Password To Connect
checkbox and the Share Mode of Dedicated, enter the
name of the computer. (See the Local Settings tab for the
name.)
5. Click the OK button. The updated information displays. An asterisk displays in
the Cfg column to indicate that the device has been configured.
6. To edit the configuration:
a) Select the device and click the Edit button.
b) Repeat steps 4-5.
Applying, Canceling, or Removing Server Settings
1. Do one of the following:
‹ To save your changes, click the Apply button. The UBox hardware
disconnects any users connected to it and restarts itself. Your UBox
disappears temporarily from the UBox application while it restarts.
Note: The Apply button is not available unless you make a change.
‹ To cancel the changes you made, click the Cancel button. The UBox does
not restart.
‹ To delete the configuration, click the Remove button. The original
information displays.
UBox User Guide 39