Lexmark 24XX-100 - Manual (Page 59)

Diagnostic Aids 3-5
24xx
Printer Default Settings
U.S. Defaults
To initialize or reset the printer to the U.S. factory defaults:
(Code page 437 Character Set 1, form length 11 inch)
1. Make sure paper and the ribbon cartridge are installed.
2. Turn the printer off.
3. Open the ribbon access cover.
4. Move the printhead toward the operator panel side of the printer
until it stops.
5. Close the ribbon access cover.
6. Press and hold Tear Off + Load/Unload while you turn the
printer on.
7. Continue holding these buttons until the carrier moves. The
operator panel lights blink several times. Once the carrier
moves, your settings have been reset to factory defaults.
World Trade Defaults
To initialize or reset the printer to the World Trade defaults:
(Code page 858, Character Set 2, form length 12 inch)
1. Make sure paper and the ribbon cartridge are installed.
2. Turn the printer off.
3. Open the ribbon access cover.
4. Move the printhead toward the operator panel side of the printer
until it stops.
5. Close the ribbon access cover.
6. Press and hold Tear Off + Tractor while you turn the printer on.
7. Continue holding these buttons until the carrier moves. The
operator panel lights blink several times. Once the carrier
moves, your settings have been reset to factory defaults.