Life Fitness Leg Extension - Manual (Page 8)

© 2006 Life Fitness, a division of Brunswick Corporation. All rights reserved.
Life Fitness is a registered trademark of Brunswick Corporation.
TCLE 6.1.06 8061001 RevA-2
Leg Extension
Assembly Instructions
NOTE: Some components have been removed from the illustration for
clarity.
16. Route the CABLE (37) beneath the CAM GUARD (30) and around the
OUTPUT CAM ASSEMBLY (A). Insert the remaining end of the CABLE
through the inner hole of the OUTPUT CAM ASSEMBLY.
Insert the CABLE RETAINING PLATE (40) over the end of the CABLE.
Install two 8mm HEX JAM NUTS (41) to the end of the CABLE.
Tighten the 8mm HEX JAM NUTS until the WORKARM begins to move
and all push pins still move in and out freely. Be sure the 8mm HEX JAM
NUTS are tight against each other.
17. Attach the OUTPUT CAM COVER PLATE (42) to the OUTPUT CAM
ASSEMBLY (A) using three M10 X 45mm BOLTS (26) and three 3/8" SAE
WASHERS (5). Tighten the BOLTS securely.
18. Place the unit in the intended place for use and check stability. If the unit
is not stable, the FEET (C) can be adjusted by inserting or removing sup-
plied SHIMS (43).
To add or remove SHIMS, loosen the LEVELING FOOT BOLT (D) and
NUT (6) until the desired SHIM(S) can be inserted or removed. Lightly
tighten the BOLT and NUT. Do not over-tighten the BOLT and NUT.
19. Install HOLE PLUGS in all open bolt holes.