Loewe Digital Recorder + - Manual (Page 8)

- 8
english
Settings for the Digital Recorder
Inform about hidden sections
For the archive playback, you can hide parts of the recording so that these
parts are skipped when you play the recording later or copy it to a recorder.
When you reach the start of a hidden section during playback, the system
informs you of this and you can undo the hide setting. The factory default
setting for this is ”yes“.
Mark ”Inform about hidden sections“.
For the setting, mark the menu line below.
Select ”yes“ or ”no“.
Setting the jump distance
For viewing with a time shift and for the archive playback, you can set a
jump distance (in minutes) to jump forwards or backwards comfortably in
the movie with the drive buttons
or . Or you can switch the jump dis-
tance off so that jumping is not possible (”no“). The factory default setting
is 2 minutes jump distance.
Mark ”Jump distance“.
For the setting, mark the menu line below.
Enter the time with the numeric buttons on the remote
control (always enter two digits for 01 to 15 minutes).
Switching Smart jump off/on
By using an intelligent jump function, you can quickly and easily feel your
way to a certain point in the recording (with a time shift or in the archive).
After each change in direction when jumping, the jump distance is cut in
half. Refer to the next page for more information on the application. The
factory default setting has Smart jump switched on.
Mark ”Smart jump“
For the setting, mark the menu line below.
Select ”yes“ or ”no“.
Setting serial recording tolerance
To avoid recording a serial episode more than once when it is shown sev-
eral times a day, a tolerance time must be entered.
The serial is then only recorded when it starts within the start time ± serial
recording tolerance. A serial tolerance of ± 30 minutes is the factory default
setting.
Mark the ”Serial recording tolerance“ menu item.
For the setting, mark the menu line below.
Enter the time with the numeric buttons on the remote
control (always enter two digits for 01 to 60 minutes).
Setting pre-record time and post record time
You can set a pre-record and post record time for timer recordings made
without VPS. This reduces the risk of parts of the programme not being
recorded because it starts earlier and/or fi nishes later. There is no factory
default setting for the pre-record time; the factory default setting for the
post record time is 5 minutes.
Call the TV menu in the TV mode.
Mark the ”Recording“ menu item.
Mark for the menu line below.
Mark ”Pre-record time“ and ”Post record time“.
Enter the time with the numeric buttons on the remote
control (always enter two digits for 01 to 15 minutes, and
for the post record time 01 to 60 minutes).
OK
OK
OK



 INFO END Digital Recorder menu
Inform about hidden sections
yes no
0 9

 
 INFO END Digital Recorder menu
Jump distance
yes, 02 min (0 – 15) ... no
AV
OK
OK
OK



 INFO END Digital Recorder menu
Smart Jump
yes no

0 9
 INFO END Digital Recorder menu
Serial recording tolerance
+–30 min (0 – 60) ...
OK
OK
AV
MENU
OK
OK
INFO END

0 9
TV menu
Recording
Pre-record time
00 min (0 – 15) ...
AV
OK
OK
OK