Lenovo 1046 - Manual (Page 53)

a. Note the top view and the bottom view of the battery card assembly. Then, insert the battery pack
harness connector into the 5-pin J3 battery pack harness connector on the backside of the battery
card assembly.
Figure 32. Bottom view of the battery card assembly
1 J3 battery pack harness connector
2 J1 connector
3 J2 board-to-board connector
Figure 33. Top view of the battery card assembly
1 Battery pack harness
b. With the front side up, place the RAID controller on a flat, clean, static-free surface.
Chapter 5 . Installing, removing, or replacing hardware 43