Removing or installing the heat sink – Lenovo 1046 User Manual
Page 68
6. Connect the system fan cables to the system board. For system fan connectors on the system board,
see Locating other connectors on the system board.
Figure 47. Installing the system fans
7. Secure the system fan cables to their corresponding clips.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation, go to “Completing the parts replacement” on page 65.
Removing or installing the heat sink
This section provides instructions on how to remove or install the heat sink.
Removing the heat sink
Attention: Do not open your server or attempt any repair before reading and understanding the “Safety information”
on page iii and “Guidelines” on page 17.
This section provides instructions on how to remove the heat sink.
CAUTION:
The heat sink might be very hot. Turn off the server and wait three to five minutes to let the server
cool before removing the server cover.
To remove the heat sink, do the following:
58
ThinkServer Installation and User Guide