LevelOne WAB-1000 - Manual (Page 25)

20
If you click on the button Select the optimal channel, a popup screen will display the
choices. This action does not select the channel for you but shows you what will most probably
be the channel selected if you leave the following dropdown menu at Yes.
Tx Pwr Mode and Fixed Pwr Level: The Tx Power Mode defaults to Auto, giving the
largest range of radio transmission available under normal conditions. As an option, the AP's
broadcast range can be limited by setting the Tx Power Mode to Fixed and choosing from 1-8
for Fixed Pwr Level (1 being the shortest distance.) Finally, if you want to prevent any radio
frequency transmission, set Tx Pwr Mode to Off.
There are a number of advanced options included on this page as described in the following
chart:
Advanced Options
Beacon
interval 0-4095 The frequency in milliseconds in which the 802.11 beacon is transmitted
by the AP.
RTS
Threshold 0-3000 The number of bytes used for the RTS/CTS handshake boundary. When
a packet size is greater than the RTS threshold, the RTS/CTS
handshaking is performed.
Fragmentation 256-2346 even only Fragmentation boundary in bytes.
DTIM 1-65535 The number of beacon intervals between successive Delivery Traffic
Identification Maps (DTIMs). This feature is used for Power Save Mode.
Basic Rates for 802.11b
-1 and 2 Mbps
-1, 2, 5.5, and 11 Mbps
The basic rates used and reported by the AP. The highest rate specified is
the rate that the AP uses when transmitting broadcast/multicast and
management frames.
Basic Rates for 802.11g or 802.11b/g mixed
Basic Rates
-1 and 2 Mbps
-1, 2, 5.5, 6, 11, 12,
and 24 Mbps
The basic rates used and reported by the AP. The highest rate specified is
the rate that the AP uses when transmitting broadcast/multicast and
management frames.
Supported Rates for 802.11b
All Rates
1 Mbps
2 Mbps
5.5 Mbps
11 Mbps
The rate at which all data frames will be transmitted.
Supported
Rate
Supported Rates for 802.11b/g mixed