LevelOne WAB-1000 - Manual (Page 29)

24
MAC Address Filtering
The factory default for MAC Address filtering is disabled. If you enable MAC Address
filtering, you should also set the toggle for Filter Type.
This works as follows:
• If Filtering is enabled and Filter Type is Allow Access, only those devices equipped with
the authorized MAC addresses will be able to communicate with the access point. In this
case, input the MAC addresses of all the PC cards that will be authorized to access this
access point. The MAC address is engraved or written on the PC (PCMCIA) card.
• If Filtering is enabled and Filter Type is Disallow Access, those devices with a MAC
address which has been entered in the MAC Address listing will NOT be able to
communicate with the access point. In this case, navigate to the report: Wireless Clients
and copy the MAC address of any Wireless Client that you want to exclude from
communication with the access point and input those MAC addresses to the MAC
address list.