LaCie LaCinema HD Connect - Manual (Page 11)

LaCinema HD Connect Introduction
User Manual page 11
1.5. Views of the LaCinema HD
Connect
1.5.1. Front View
1. Infrared receiver – Receives the infrared signal from the remote
control. Make sure the receiver is not obstructed.
Stand-by button – By default, pushing this button puts the drive
into stand-by mode or wakes it from standby (this behavior can
be modified; see
1.7. Power Management for more details)
2. Blue status light – If the drive is connected to a TV or computer,
this light will be on. It will turn off when disconnected.
3. USB port (connect disk) – Connect a USB disk, digital camera,
or card reader to access its multimedia files directly from your
TV.
1.5.2. Rear View
1. USB 2.0 host – Connect a USB disk, digital camera, or card
reader
2. Ethernet connector – Connect to your home network via an Eth-
ernet cable to your router
3. Optical audio out – Connect to digital home amplifier
4. Video composite + stereo connector – Connect to any TV (CRT)
5. HDMI – Connect to a High Definition flat screen TV or video
projector
6. Power connector – Must be connected when the drive is at-
tached to a TV. When connected to a computer, the drive is
bus powered through the USB connection, but if your computer
does not provide enough power through the USB port, connect
the power supply.
CAUTION: Do not stack another electronic device on or below
the LaCinema HD Connect or place it in an enclosed area to avoid
performance and overheating issues (
Fig. 06 ).
Fig. 04
Fig. 05
Fig. 06