Lennox Hearth PERFORMER SWS210 - Manual (Page 14)

14 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
1. Check that all chimney pipe joints are securely fastened.
2. Check that the heater is securely fastened to the floor (if ap-
plicable).
3. Make sure the intake vent has clear access to outside air (if ap-
plicable).
4. Make sure the outside air vent has been sealed properly to keep
rodents out (if applicable).
5. Be sure all roof flashings are watertight.
6. Be sure the stove is properly grounded (if applicable).
FOR YOUR OWN PROTECTION AND INSURANCE PURPOSES,
HAVE YOUR CHIMNEY AND CONNECTOR PIPE INSTALLATION
INSPECTED BY YOUR LOCAL BUILDING CODE AUTHORITY OR
FIRE MARSHAL BEFORE STARTING A FIRE IN YOUR STOVE.
NOTIFY YOUR INSURANCE COMPANY.
CAUTION: Wear gloves during brick installation in case of
sharp edges inside the stove.
Note: Installation of the baffle boards and baffle blankets are easier when
you can still access the flue outlet, (before connecting the flue vent). Be
sure the baffle blankets are placed flat on the baffle boards so as not
to block exhaust flow to the flue. Use a ruler or a piece of kindling to
reach over the baffle blanket to be sure it is completely flat on top of the
baffle boards.
Measure bricks before installing, as per list of dimensions on next
page, to be sure the correct bricks are installed in the correct location.
1. Install bricks #1-26 in the numbered sequence shown in Figure
14 on Page 15.
Note: Before installing your baffle boards make sure the stainless
steel tube support and front and rear tube hangers are centered
side to side and that the front and rear hangers are hooked onto
the stainless steel pins protruding from the rear of the airwash
and the stove back.
2. Next, you will install the baffle boards. All 4 baffle boards included
are the same size. You will start by installing the boards in the
center part of the unit on top of the secondary tubes to each side
of the baffle support with the 15” side of the baffle board going
from the front to back of the unit. Once you have the first two
boards installed slide the board to the left side of the baffle sup-
port all the way to the left and rear of the unit. You will slide the
board to the right side of the secondary support to the right and
rear of the unit. Next you will install the two remaining boards
where you originally installed the first two boards on each side
of the baffle support and pushed against the rear of the unit. The
stainless steel support hanger should be centered left to right
between the sets of baffle boards and placed as shown in Figure
15 on Page 15.
POST INSTALLATION CHECKS BRICK INSTALLATION