Lennox Hearth GRANDVIEW P/N 506033-56 User Manual

Lennox Hearth Tools

Advertising
background image

GRANDVIEW™ BLOWER KIT

INSTALLATION INSTRUCTIONS FOR INSTALLING ThE BLOWER
ON A GRANDVIEW™ 230 WOODSTOVE

P/N 506033-56

Rev. NC, 08/2011

HEARTH PRODUCTS

KITS AND ACCESSORIES

KIT CONTENTS

Please ensure that all these parts are included

1 ea. Blower w/snap switch assembly

6 ea. 10-24 Screws

4 ea. Tinnerman nuts

Grandview™ Blower Kit

Cat. No.

Model

Description

h8350

BLWR-GV-700-SS

Blower

1

TOOLS NEEDED

Flat Head Screwdriver

5/32” Allen Wrench

1/8” Allen Wrench

GENERAL INFORMATION

If you encounter any problems, need clarification of these instructions or

are not qualified to properly install this kit, contact you local distributor

or dealer.

Read this instruction sheet in its entirety before beginning the installa-

tion.

ALL WARNINGS, PRECAUTIONS AND INSTRUCTIONS IN ThE INSTAL-

LATION AND OPERATION MANUAL PROVIDED WITh ThE APPLIANCE

APPLY TO ThESE INSTRUCTIONS.

Check the contents of the kits upon receipt and check for any damaged

or missing parts. If there is hidden damage, notify your freight company

or Lennox Hearth Products dealer immediately.

CAUTION: Wear gloves during installation in case of sharp

edges on the stove.

INSTALLATION INSTRUCTIONS

Step 1. Remove round knockout plate on back of stove by removing the

screw on the top of the knockout with a 5/32” allen wrench. You

can then push on the top and bottom of the plate to loosen for

removal.

Step 2. Install the four supplied flat Tinnerman nuts into the four rect-

angular slots on the back of the stove. Use of a flat head screw

driver will be necessary.

Figure 1

Snap Switch

Tinnerman Nut

NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE.

Advertising