LG LT1030HR - Manual (Page 11)

Owner’s Manual 11
ENGLISH
Installation
Installation
Remove packing sheet from the back of the sleeve, and
packing corner and blue tape from the air conditioner.
INSTALLATION REQUIREMENTS
If you use an existing wall sleeve, you should
measure its dimensions.
Install the new air conditioner according to these
installation instructions to achieve the best
performance. All wall sleeves used to mount the
new air conditioner must be in good structural
condition and have a rear grille to securely attach
the new air conditioner. (FIG. 1)
With the LGE sleeve(optionally supplied with your
unit), you can maintain the best performance of the
new air conditioner. (FIG. 2)
ELECTRICAL SERVICE
Check your available electrical service. The power
supply available must be the same as that shown
on the unit nameplate (found on left side of
cabinet).
All models are equipped with a 3-prong service
plug to provide proper service and safe positive
grounding. Do not change plug in any way. Do not
use an adapter plug. If your present wall outlet does
not match your plug, call a qualified electrician to
make the necessary corrections. SAVE CARTON
for storage and this OWNER'S MANUAL for future
reference. The carton is the best way to store unit
during winter or when not in use.
INSTALLATION HARDWARE
14- 13 / 32 "
(366 mm)
24- 21 / 32 "
(626 mm)
18"(458 mm)
19- 21 / 32 "
(499 mm)
M OD E TIM ER
PO W ER
FA N SP EE D
Fa n He at
En ergy Sa ver Co ol
Tim er TE M P 'F F1 L OW F2 H IG H
1
4
5
6
7
3
2
8
2 Size options
2 Size options
9
To avoid risk of personal injury, property damage, or product
damage due to the weight of this device and sharp edges
that may be exposed:
• Air conditioners covered in this manual pose an excessive
weight hazard. Two or more people are needed to move
and install the unit.
To prevent injury or strain, use proper lifting and carrying
techniques when moving unit.
• Carefully inspect location where air conditioner will be
installed. Be sure it will support the weight of the unit over
an extended period of time.
• Handle air conditioner with care. Wear protective gloves
whenever lifting or carrying the unit. AVOID the sharp
metal fins of front and rear coils.
• Make sure air conditioner does not fall during installation.
REQUIRED TOOLS:
• Tight Fitting gloves
• Standard screwdriver
• Phillips screwdriver
• Pliers
• Sharp knife
• 3/8-inch open end
wrench or adjustable
wrench
• 1/4-inch hex socket
and ratchet
• Tape measure
• Electric drill
• 1/4-inch drill bit
FIG. 1
Air Conditioner
ITEM NAME OF PARTS Q'TY
1 PLASTIC GRILLE 1
2 HORIZONTAL INSULATION STRIPS 2
3 AROUND INSULATION STRIPS 2
4 SUPPORT BLOCK 2
5 BAFFLE 1
6 TRIM FRAME 2
7 SHIM 2
8 PLASTIC NUTS AND WASHER SCREWS 4
9 GRILLE REAR 1
15- 17 / 32 "
(394 mm)
16- 23 / 32 "
(425 mm)
25- 7 / 8 "
(656 mm)
Expanded
aluminum metal grille
FIG. 2
LGE Wall Sleeve