LG LT1030HR - Manual (Page 18)

18 Room Air Conditioner
Operating Instructions
Operating Instructions
Controls
The controls will look like one of the following.
MODE TIMER POWER
FAN
SPEED
Fan
Heat
Energy
Saver
Cool
Timer
TEMP
' F
F1 LOW
F2 HIGH
REMOTE CONTROL SIGNAL
RECEIVER
POWER
MODE
- Push this button to shift mode of operation from COOL → ENERGY SAVER → FAN → HEAT
- COOL:
• Fan runs continually for normal cooling operation.
- ENERGY SAVER:
• The fan stops when the compressor stops cooling. Approximately every 3 minutes the fan will turn on and the unit will
check the room air temperature to determine if cooling is needed.
- FAN:
• Fan-only operation.
- HEAT:
• Fan runs continually for normal heating operation.
TIMER
- SHUT-OFF TIME
• You will usually use shut-off time while you sleep.
• If unit is running, use Timer to set number of hours until shut-off.
• For your sleeping comfort, once Time is set, the Temperature
setting will raise 2
°
F after 30 min., and once again after another
30 min.
• Push Timer button to advance setting from 1Hour → 2Hours → ...
→ 12Hours maximum.
- START TIME
• If unit is off, use Timer to set number of hours before unit starts.
• Push Timer button to advance setting from 1Hour
→ 2Hours → ...
→ 12Hours maximum.
TEMPERATURE SETTING
• Use this button to automatically control the
temperature of the room.
The temperature can be set within a range of
60
°
F to 86
°
F by increments of 1
°
F.
• The setting appears in the display.
• To turn the air conditioner ON, push this button.
To turn the air conditioner OFF, push the button
again.
• This button takes priority over any other button.
FAN SPEED
• Every time you push this button, it advances the setting as follows: {High[ F2 ] → Low[ F1 ] → High[ F2 ]}
AUTO RESTART
When power is restored after an electrical power failure, the unit will begin to run at its last setting.