Linksys FESWSK05 v3 - Manual (Page 11)

Instant EtherFast ® Series
4. Select Search for the best driver for your device (Recommended) and
select Specify a location. Then, type “A:\WINME” in the drop-down box
and click Next.
5. A window will open, notifying you that Windows is searching for the
Linksys LNE100TX Fast Ethernet Adapter driver. When the window notifies
you that it is ready to install the driver, click Next.
5. Windows will begin installing the driver. At this point, the installation may
require files from your Windows Millennium CD-ROM. If prompted, insert
your Windows Millennium CD-ROM into your CD-ROM drive and enter
Installing the Drivers for Windows
Millennium
After physically installing the LAN Card in your computer, follow these
instructions to install the network driver. The installation procedure for the net-
work driver will depend on your current system configuration. If at any time
during the installation you encounter problems, consult the Troubleshooting
section.
Installing the Network Card’s Driver
1. If you haven’t already, start up your computer.
2. Windows Millennium will automatically detect the presence of the PCI
Ethernet Controller hardware in your computer.
3. Insert the EtherFast ® 10/100 LAN Card Driver Disk into your floppy drive
while the Add New Hardware Wizard window is visible. Select Specify the
location of the driver (Advanced) option. Click Next.
Overview
Installing the LAN Card’s Drivers
16 15
Fast Ethernet Switched 10/100 Network In a Box