Nstallation, Uidelines – Liebherr CS 16 User Manual

Page 3

Advertising
background image

3

I

NSTALLATION

G

UIDELINES

!

WARNING

ELECTRICAL SHOCK HAZARD

• Electrically ground refrigerator.

• Do not use an extension cord.

• Failure to follow these instructions

could result in fire or electrical shock.

!

WARNING

ELECTROCUTION HAZARD

Electrical Grounding Required. This

appliance is equipped with a three-prong

(grounding) polarized plug for your

protection against possible shock hazards.
DO NOT remove the round grounding

prong from the plug.
DO NOT use a two-prong grounding

adapter.
DO NOT use an extension cord to

connect power to the unit.

Customer’s Responsibility

A 115 Volt, 60 Hz, 15 Amp (20 Amp for side-by-

side installation) fused electrical supply is required.

We recommend using a dedicated circuit for this

appliance to prevent electrical overload. Follow

the National Electrical Code and local codes and

ordinances when installing the receptacle.

Blocking For Safety

The anti-tip brackets must be installed to prevent

the unit from tipping after it is installed. Refer to

Blocking For Safety.

Unit Venting

DO NOT restrict the air flow. Air flow must be

provided for the unit to operate. The factory air

vents provide 31 square inches (200 cm2) of air

flow. If you are replacing the factory air vents with

an overlay, the air flow must be the same or greater

than the factory air vents.

Area Requirements

Verify the following:

• Floors can support refrigerator’s weight plus

approximately 1200 pounds (544 kg) of food

weight.

• Finish kitchen floor height is level. Refrigerator

must be shimmed to the floor level if the floor

heights are not equal to make sure air vents are

not obstructed.

• Remove anything attached to rear or side walls

that can obstruct refrigerator opening.

• Cutout dimensions are accurate.

• Electrical outlet is in correct location.

Do not install this refrigerator-freezer next to any

other refrigerator or model except another Liebherr

model.Liebherr models are designed to allow side-

by-side installation.They are equipped with

a heating system to eliminate condensation when

refrigerators or freezers are installed side-by-side.

Installing this refrigerator-freezer next to any other

refrigerator or freezer can cause condensation or

cause damage to the Liebherr refrigerator-freezer.

Electrical Requirement

If codes require a separate grounding circuit to be

used, have a qualified electrician install the circuit.

!

WARNING

Do not ground to a gas pipe. Check with

a qualified electrician if you are not sure

the appliance is properly grounded. Do not

have a fuse in the neutral or grounding

circuit.

Advertising