Liebherr CS 16 - Manual (Page 7)

Figure 5: Secure the appliance in place so it does
not tip forward when the fully stocked door is opened.
Two anti tipping brackets are included with the unit.
1. Mark the center of the appliance on the back wall.
2. Also mark the install height of the tipping brackets
on the back wall .(Min. 3-3/8", Max 4").
3. Screw the first anti tipping bracket in a wall stud,
make sure that it is within the 9-1/2 "(241 mm)
right or left from the center line of the appliance.
The screws has to extend a minimum of 1-1/2"
(38 mm) into the studs.
4. Place the second anti tipping bracket in a stud or
in the wall using proper anchor material but within
the maximun distance of the center line 9-1/2"
(241 mm).
5. Push the appliance against the back wall.
6. Using the adjustable roller base, raise the unit
until the compressor mounting plate makes con-
tact with the brackets. Make sure the front leve-
lers are firmly on the floor to prevent appliance
from tipping forward.
Refer to " Leveling the Refrigerator" Fig. 2.
Wall stud
1.
2.
Wall
Center line
of appliance
Min. 3 - 3/8 (86 mm)
Max. 4
"
" (102 mm)
Max. 9 - 1/2
(241 mm)
"
Max. 9 - 1/2
(241 mm)
"
=
=
Important
At least one bracket must
be mounted to a wall stud.
Figure 5
7
B
LOCKING
F
OR
S
AFETY