Liebherr CS 16 - Manual (Page 6)

6
I
NSTALLATION
A gap of at least 2 inches (51 mm) depth must
be provided behind and along the entire width of
this unit to ensure sufficient ventilation. The area
of ventilation above the unit should be at least 18
square inches (116 cm2). The greater the area the
more economically the appliance will run.
1. When installing with standard kitchen units,
maximum depth of 22-13/16 inches (580 mm)
and decor panels of maximum 1/16 inch (2 mm)
thickness, the appliance can be set up right next
to the kitchen unit. The door protrudes 1-5/16
inches (34 mm) from the side of the kitchen unit
and 2 inches (51 mm) at the front. This enables
it to be opened and closed without difficulty.
2. When setting up the appliance next to a wall
(Fig. 4, 4), a minimum distance of 1-7/16 inches
(36 mm) must be provided on the hinge side
between the appliance and the wall (for the
handle when the door is open).
3. If you wish to attach the appliance to adjacent
units or to fit a spacer between the appliance
and the wall, please note the following:
• Verify that the door can open and close
properly.
• Do not drill any holes in the side walls
in Figure 4. Liebherr refrigerator/freezer
combinations are equipped with a heating
element to eliminate condensation when units
are installed side by side. This element and
foamed components can be damaged.
Installing
- Figure 4
B
A
C
ca. 36
min.
200 cm 2
4
3
2
1
(1) Top unit
(2) Refrigerator/freezer
(3) Kitchen unit side panel
(4) Wall
A. 24-13/16" (630 mm)
B. 22-13/16" (580 mm)
C. 2" (51 mm)
Figure 4
The appliance can be installed in a row of kitchen
units. To adapt the height of the appliance to the
surrounding furniture a top unit (Fig. 4, 1) can be
added.