LevelOne MUS-2500 - Manual (Page 11)

11
Chapter 3 Hardware Setup
1. Press the panel cover up at mark

and pull the bottom case off.
2. Insert the HD into the IDE slot. You must carefully align and plug the pins of the hard drive’s
IDE connector into the sockets of the controller board’s IDE adapter in the base case of the
enclosure. Do NOT force the pins into their sockets and do NOT try to insert the hard disk at
an angle, otherwise you may damage the IDE connector pins.
3. Attach the screws (Silver) to the base and the hard drive.
4. Fix the panel cover on the base.
5. Attach the screws (Black) to the base and the panel cover.