Lava Computer DSerial-PCI/LP Card - Manual (Page 2)

Windows NT 4.0 Installation
1. With the power turned off, insert the DSerial-PCI/LP card into any
free PCI slot in your PC. Boot NT logging on as “Administrator”.
2. Place the DSerial-PCI/LP installation diskette into your floppy drive
and select Run from the Start Menu. When prompted type:
A:\NT4.0\Setup.
3. After the necessary files have been copied, select My Computer and
start Control Panel. A new icon will appear called “LavaPort”.This
applet should now be used to configure ALL Com Ports in your PC –
not just Lava serial ports.
Please note that Com 1 may not appear in this applet if you have your
mouse attached to Com 1.