Lava Computer DSerial-PCI/LP Card - Manual (Page 3)

DOS and Windows 3.x Installation
1. With the power turned off, insert the DSerial-PCI/LP card into any
free PCI slot in your PC. Turn your PC on.
2. Place the DSerial-PCI installation diskette into your floppy drive.
In the Win3.11\16550 subdirectory of this diskette you will find a file
called “Lavaconf.exe”. Copy this file to your hard drive and run it.
3. When run, Lavaconf.exe will display two I/O addresses and one IRQ.
These correspond to the addresses and IRQ chosen by your PC when
configuring the DSerial-PCI
. Make a note of them.
4. If you are using Windows 3.x, start Windows and go to Control Panel
| Ports. Choose Com 3 for Port 1 and Com 4 for Port 2 on the DSerial-
PCI
. Click the Advanced button and enter the I/O address and IRQ
for each port as reported by Lavaconf.exe. Reboot your PC for these
changes to take effect.
Note: DOS and Windows 3.X support a maximum
of four Com Ports in a PC.
/LP
/LP
/LP