Lennox Hearth COUNTRY 506033-16 - Manual (Page 2)

2
Printed in U.S.A. © 2009 Lennox hearth Products
P/N 506033-16 REV. A 05/2009
NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE.
Lennox Hearth Products reserves the right to make changes at any time, without notice, in
design, materials, specifications, prices and also to discontinue colors, styles and products.
Consult your local distributor for fireplace code information.
1110 West Taft Avenue • Orange, CA 92865
MANUFACTURED hOME REqUIREMENTS
Step 5. Install the Outside Air Kit per the instructions provided in kit
(order cat. no. 71112).
Step 6. In Manufactured (mobile) Home installations the stove must
be bolted to the floor through the pedestal base, on both sides,
using 1/4” Ø lag screws (not provided). The lag screws must be
of an adequate length to extend through the hearth pad and into
the floor. Seal any irregularities with silicone sealer.
Step 7. If installed in a manufactured (mobile) home, the heater must be
grounded to the chassis with a #8 AGW copper wire or equiva-
lent.
SEE ThE INSTALLATION AND OPERATION MANUAL FOR ADDITIONAL
REqUIREMENTS FOR MANUFACTURED (MOBILE) hOME INSTALLA-
TIONS.