Life Fitness 9500HR - Manual (Page 28)

28
HOW TO REMOVE THE HOUSING ON THE
LIFECYCLE 9500HR AEROBIC TRAINER
Step 1
Remove the left-side PEDAL (the user’s left side; small hole-side of the housing) by
turning the PEDAL NUT clockwise with a 5/8” open-end wrench, then remove the
right-side PEDAL by turning the PEDAL NUT counter-clockwise.
Step 2
Remove the two SCREWS securing the right and left COLLAR HALVES to the
FRAME.
Step 3
Remove the screw securing the right SEAT POST SHROUD to the left SEAT POST
SHROUD and gently remove both sides from the SEAT POST.
Step 4
Remove the eight screws (total) from the right side of the shroud at the locations
shown in the illustration on the next page.
Step 5
Swing the right-side CRANK ARM to the two o’clock position and carefully, to avoid
scratching or damaging the shroud, guide the right-side HOUSING up and over the
CRANK ARM and remove from the machine.
Step 6
If you need to remove the user left side of the HOUSING, remove the two internal
SCREWS still securing the left-side HOUSING to the FRAME. Swing the left-side
CRANK ARM to the two o’clock position and carefully, to avoid scratching or dam-
aging the shroud, guide the left-side HOUSING up and over the CRANK ARM and
remove from the machine.
Step 7
Reverse steps 1-5 to return shroud to its original position.