Lowrance electronic 3600C - Manual (Page 76)

70
Press
↑ or ↓ to change the first character, then press → to the next
character and repeat until the name is correct.
4. When your adjustments are finished, return to the last page dis-
played by repeatedly pressing
EXIT .
IMPORTANT ALARM NOTES:
Anchor Alarm - The anchor alarm may be triggered even when
you're sitting still. This typically happens when using small (less
than .05 mile) anchor alarm ranges.
Arrival Alarm - If you set the arrival alarm's distance to a small
number and you run a route (see the Navigate Routes segment),
this unit may not show navigation data to the next waypoint, once
you arrive at the first one, since you may not be able to come close
enough to the first waypoint to trip the arrival alarm.
NMEA 2000 Alarm
The NMEA 2000 Alarm can be set to monitor multiple EP-10 Fuel Flow
and EP-15 Fluid Level sensors. You can set a threshold for each alarm
in its corresponding Percent box. Thresholds give you control over when
the alarm will go off. You may want the alarm to go off when the black
water tank is filled to 75 percent of its capacity, likewise, you may want
to know when the fuel level falls below 30 percent of tank capacity.
To get to the NMEA 2000 Alarms menu, press MENU , select NMEA 2000
and press ENT . Choose NMEA 2000 A LARMS
and press ENT .
NMEA 2000 Alarms selected (left). NMEA 2000 Alarms menu (right).
1. With the Fluid Level Device window highlighted, press ENT and use
↑ ↓ to select the device you want to monitor, then press
ENT .
2. To enable the Full Alarm, highlight F ULL A LARM
Enabled box and
press ENT to turn on (check) the alarm. Press
→ to the Percent box and