Lennox Hearth SPECTRA CI1000HT - Manual (Page 2)

Printed in U.S.A. © Lennox Hearth Products 2003
P/N 775,092M REV. B 09/2007
Lennox Hearth Products reserves the right to make changes at any time, without notice, in design,
materials, specifications, prices and the discontinuance of colors, styles and products. Consult
your local distributor for fireplace code information.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
1110 West Taft Avenue • Orange, CA 92865
Step 5. Install Top Rope Gasket - Place the top rope along the top edge of
the casting and press down firmly.
Note: Ensure gasket is positioned so it will not be visible from the
front (see Figure 5).
Step 6. Clean Glass - Prior to installing the window trim, the glass should
be cleaned thoroughly with a glass cleaner using a soft cloth. A
household ammonia based glass cleaner is approved (see noteS
below).
Note:
For woodstove models CI1000HT and CI2000HT, when cleaning
the inside of the glass after it has been burned, a commercial glass
cleaner designed for stoves is recommended.
For woodstove models CI1000HT and CI2000HT, when cleaning
the inside of the glass after it has been burned, a commercial glass
cleaner designed for stoves is recommended.
Step 7. Install Trim - Position the locating nub on the top center of the trim
into the notch on the top center of the window opening (see Figure
6).
While slightly lifting up on the trim rotate the bottom of the trim to
the glass. Let the trim drop down until the 2 nubs on the bottom
of the trim drop into the slots on window opening (see Figure 7).
Figure 5 - Install Top Rope Gasket
2
Figure 6 - Position Locating Tab at Top Center
Figure 7 - Lift and Rotate Trim into Place