Lindy 70570 - Manual (Page 2)

- 2 -
1. Introduction
This PCI Host Adapter is a PCI controller board which can upgrade your desktop
computer to have Gigabit Ethernet (1000Mbps, 100 Mbps, 10 Mbps) and three USB2.0 /
USB1.1 ports.
The board supports a 32-bit 33 MHz PCI bus revision 2.2, USB transfer rate of 1.5Mb/s,
12Mb/s, 480Mb/s and Gigabit Ethernet 10/100/1000Base-T.
This Low Profile Form factor can support Low profile PCI and regular PCI both.
It comes with drivers for Windows.
1.1. Features
1.1.1. PCI Interface
Compliant with PCI Specification, revision 2.2.
32 bit, 33MHz fully compliant PCI host interface.
Integrated PCI DMA engines.
1.1.2. 1000Base-T Gigabit Ethernet
o
Fully compliant with IEEE 802.3 (10Base-T Ethernet), IEEE 802.3u (100Base-TX
Fast Ethernet), IEEE 802.3z (1000Base-T Gigabit Ethernet)
o
Supports Ethernet 10Mbps (half-duplex), Ethernet 20Mbps (full-duplex), Fast
Ethernet 100Mbps (half-duplex), Fast Ethernet 200Mbps (full-duplex), Gigabit
1000Mbps (full-duplex) and Gigabit 2000Mbps (full-duplex)
o
RJ-45 Port offer high speed transmission over CAT 5 UTP cable
o
Green LED indicator for 10/100/1000 Link
o
Red LED indicator for ACT (Tx / Rx)
o Auto-Negotiation with Next page capability
o Supports pair swap/polarity/skew correction
o Crossover Detection & Auto-Correction