Lindy CPU SWITCH - Manual (Page 2)

Page 2 Installation & Use – English Guide LINDY ELECTRONICS LTD
Radio Frequency Energy
Shielded cables must be used with this equipment to maintain compliance with radio frequency
energy emission regulations and ensure a suitably high level of immunity to electromagnetic
disturbances.
European EMC directive 89/336/EEC
This equipment has been tested and found to comply
with the limits for a class B computing device in
accordance with the specifications in the European
standard EN55022. These limits are designed to
provide reasonable protection against harmful
interference. This equipment generates, uses and can
radiate radio frequency energy and if not installed and
used in accordance with the instructions may cause
harmful interference to radio or television reception.
However, there is no guarantee that harmful
interference will not occur in a particular installation. If
this equipment does cause interference to radio or
television reception, which can be determined by
turning the equipment on and off, the user is
encouraged to correct the interference with one or
more of the following measures: (a) Reorient or
relocate the receiving antenna. (b) Increase the
separation between the equipment and the receiver.
(c) Connect the equipment to an outlet on a circuit
different from that to which the receiver is connected.
(d) Consult the supplier or an experienced radio / TV
technician for help. FCC Compliance Statement (United States)
This equipment generates, uses and can radiate radio
frequency energy and if not installed and used
properly, that is, in strict accordance with the
manufacturer’s instructions, may cause interference to
radio communication. It has been tested and found to
comply with the limits for a class A computing device
in accordance with the specifications in Subpart J of
part 15 of FCC rules, which are designed to provide
reasonable protection against such interference when
the equipment is operated in a commercial
environment. Operation of this equipment in a
residential area may cause interference, in which case
the user at his own expense will be required to take
whatever measures may be necessary to correct the
interference. Changes or modifications not expressly
approved by the manufacturer could void the user’s
authority to operate the equipment.
Canadian Department of Communications RFI
statement
This equipment does not exceed the class A limits for
radio noise emissions from digital apparatus set out in
the radio interference regulations of the Canadian
Department of Communications.
Le présent appareil numérique n’émet pas de bruits
radioélectriques dépassant les limites applicables
aux appareils numériques de la classe A prescrites
dans le règlement sur le brouillage radioélectriques
publié par le ministère des Communications du
Canada.