Lanier 5625 User Manual
Page 54
Copying
42
2
❒ Select one of the following settings or keys:
•
[Normal]
: normal paper
•
[Thick]
: thick paper, post cards, adhesive labels, translucent paper
•
[OHP]
: OHP transparencies
•
[Duplex]
: Use for copying onto the reverse side of paper that has been al-
ready copied onto.
⇒
P.48 “Copying onto the reverse side of paper”.
•
[Duplex Thick]
: Use for copying onto the reverse side of thick paper (105-
160g/m
2
, 28-43 lb) that has been copied onto.
⇒
P.48 “Copying onto the re-
verse side of paper”.
•
[Custom]
: Use to specify a non-standard sized.
⇒
P.44 “Copying onto non-
standard size paper with the bypass tray”.
❒ If the copy paper is bent, correct it before setting paper in the bypass tray. If
the bend is not corrected, a paper misfeed might occur.
❒ When you copy onto OHP transparencies, you can select whether a blank slip
sheet is inserted between OHP transparencies.
❒ When you set several sheets at a time, fan them to get air between them before
loading.
❒ If the copy paper is curled, gently roll it to remove the curl.
❒ When you copy onto OHP transparencies, insert them with the copy side up.
❒ Do not stack copy paper above the limit mark.
❒ When setting non-standard size paper, be sure to set the size after pressing
the
[Custom]
key.
Copying onto standard size paper with the bypass tray
Note
❒ When you copy onto the reverse side of paper that has been already copied
onto,
⇒
P.48 “Copying onto the reverse side of paper”.
Number of sheets that can
be set at one time
Normal paper: 50 sheets
Thick paper, OHP transparencies: 30 sheets (smaller
than 8"
×
13"), 15 sheets (8"
×
13" or larger)
Adhesive labels: 30 sheets
Translucent paper: 50 sheets
Post cards: 25 sheets