Lowrance electronic LCX-111C - Manual (Page 132)

124
NOTE:
To load a Navionics

chart, see Sec. 8 for the entry Navionics Charts.
GPS Data files:
GPS Data Files contain waypoints, routes, trails and event marker
icons. Instructions for copying GPS Data Files between your computer
and a MMC are contained in the instruction manual for your MMC
card reader and MapCreate 6 software.
GPS data automatically recorded in the unit's internal memory must be
saved to the MMC as a GPS Data File to store it on your personal
computer. GPS Data Files stored on a MMC must be copied from the
card to the unit's internal memory before the unit can read them.
Here's how:
1. Insert the MMC into your unit. Press MENU | MENU | ↓ to S
YSTEM
S
ETUP
| ENT | ↓ to T
RANSFER
M
Y
D
ATA
| ENT and the screen below appears.
The Transfer My Data submenu asks if you want to save data to the
MMC or load data from the MMC into the unit's memory.
2. The Transfer My Data menu includes a message that tells you if a
MMC is present or not. If no MMC is present, you must insert a card
into the unit to activate the Load or Save commands.
To transfer data from the unit to the MMC: press ENT (for S
AVE
.)
To transfer data from the MMC to the unit: press → to L
OAD
| ENT .
3. Saving to MMC: To accept the default name "Data" for the GPS
Data File, press
↓ to
S
AVE
D
ATA
| ENT . If you wish to rename the file (as
shown in the following figures), press ENT to activate the Data File
name selection box. Press
↑ or ↓ to change the first character, then
press → to the next character and repeat until the name is correct.
Then, press ENT |
↓
to S AVE D ATA
| ENT .