LSI 7102XP-LC - Manual (Page 67)

OpenBoot BIOS 4-9
Copyright © 2002 - 2005 by LSI Logic Corporation. All rights reserved.
Target 4
Unit 0 Disk SEAGATE ST39173FC 6258
WWN 210000203710324a Port ID 73
/pci@8,700000/scsi@6
Target 6
Unit 0 Removable Read Only device PLEXTOR CD-ROM PX-20TS
If the FC devices on your IntraServer™ adapter are not identified by your
system, check the following:
•
Is the FC enclosure powered on?
•
Does the LED on the adapter indicate Link? (Note that Link is valid
only after the device is probed.)
•
Does the LED on the switch or remote enclosure indicate Link?
•
Does the Link-SPEED parameter selected by the adapter match that
of the bus (1G, 2G, or Auto)?
If you do not see disks, the following additional debug information may
help to identify the problem.
4.7.3 Verifying Installation
Use the following procedure to verify installation of your Fusion-MPT
adapter in the system:
Step 1. Power-up the system.
Step 2. When the banner is displayed, press the STOP+A keys to
interrupt the boot process and stop at the ok prompt.
Step 3. Use the show-devs command to list the system devices. You
should see an output similar to the following:
ok show-devs
/SUNW,UltraSPARC-III@0,0
/virtual-memory
/memory@m0,0
/aliases
/options
/openprom
/chosen
/packages