Lathem DDC2 - Manual (Page 20)

Digital Display Wall Clock Guide Page 14
» Slide the front panel display back into the case, replace the end cap and secure with the two
phillips head screws.
Double Mount - Wall
DDC2 Requires optional mounting kit (SAM0630)
DDC4 Requires optional mounting kit (SAM0625)
Tools required for mounting the clock:
Flat blade screwdriver
Phillips head screwdriver
15/16" open end wrench
The double wall mount plate attaches to a double or single gang box installed securely in the wall. Required
wiring should be available through the gang box at time of installation.
»
Remove the two chase nipples from the mounting plate posts.
» Run the required wiring from the gang box through one of the mounting posts of the mounting
plate.
» Secure the mounting plate securely to the gang box with the proper screws. (not supplied)
Keyholes for
wall mount
Vent holes
For 1/2"
conduit
For single
gang box
mount
Figure 3