Installation – Lennox Hearth VIS35 User Manual

Page 9

Advertising
background image

9

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

Installation

b

affle

& l

og

s

et

i

nstallation

Baffle

The cast iron baffle is wrapped in foam and shipped between

the outside of the firebox and the outer shell of the stove.

Remove the foam and install the baffle in the rectangular

hole in the top of the firebox. The baffle rests unsecured in

the hole.

Log Set & Embers

Caution: If the logs are not properly installed, your

stove will not function properly.

Parts list: rear log, left front log, right front log, and

straight twig

1) Remove the logs from the box and carefully unwrap them.

The logs are fragile so handle them with care.

2) Align the holes in the bottom of the rear log (the longest

log in the set) with the two pegs just to the rear of the

rear burner tube and slide the log down onto the pegs

(Figure 10). The charred black surface of the log should

face the front.

3) The left front log has two pegs protruding from the top

surface (Figure 11). The charred black with white highlights

surface of the log should be facing forward. Slide this log

down onto the left front and center front pegs.

4) The right front log (positioned with the black charred

surface towards the front) should be placed on the peg

protruding from the right end of the left front log and the

remaining peg at the right end of the metal log support

panel (Figure 11).

5) The remaining straight twig has two holes in the bottom.

Position the twig so the black and white charring is to the

front and slide the holes over the peg in the left front log

and the peg in the rear log (Figure 12). It may be neces-

sary to roll the top of the rear log slightly forward to put

this twig on the pegs.

6) Figure 13 shows the entire log set assembled. The embers

provided may be placed one high in front of the front

burner tube using care not to cover all the burner ports.

Any extra embers may be placed at the ends of the front

log, off the burner. Place small pinches of rockwool on

top of the embers.

Figure 10

Figure 11

Figure 1

Pilot

Viewing

Embers

Figure 1

Note the location of the hole for viewing

the pilot light. When the pilot is

burning, a blue flame can

be seen through this

hole.

Advertising
This manual is related to the following products: