Linksys SLM2005 - Manual (Page 17)

Chapter  Advanced Configuration
1 5-Port and 8-Port 10/100/1000 Ggabt Smart Swtches wth PD and AC Power
Rx Frames Displays the number of frames received on
the port since the device was last refreshed.
Tx Errors Displays the number of transmitted packets
with errors that have occurred on the port since the device
was last refreshed.
Rx Errors Displays the number of received packets with
errors that have occurred on the port since the device was
last refreshed.
Tx Broadcast Displays the number of good broadcast
packets transmitted on the port since the device was last
refreshed.
Rx Broadcast Displays the number of good broadcast
packets received on the port since the device was last
refreshed.
Statistics > IGMP Status
From the IGMP Status screen, you will see the IGMP Status
for each VLAN interface.
Statistics > IGMP Status
VLAN ID Displays the VLAN ID .
Querer Indicates the IGMP router is active or idle.
Queres Transmtted Displays the number of queries
that have been transmitted.
Queres Receved Displays the number of queries that
have been received.
v1 Reports Displays the number of IGMP v1 report
packets that have been received by the Switch.
v Reports Displays the number of IGMP v2 report
packets that have been received by the Switch.
v Leaves Displays the number of IGMP v2 leave packets
that have been received by the Switch.
Multicast > IGMP Settings
When IGMP Snooping is enabled globally, all IGMP packets
are forwarded to the CPU. The CPU analyzes the incoming
packets and determines:
The ports that want to join which Multicast groups and
issue the IGMP join packet •
The ports that have Multicast routers generating IGMP
queries
Ports requesting to join a specific Multicast group issue an
IGMP report, specifying that Multicast group is accepting
members. This results in the creation of the Multicast
filtering database.
Multicast > IGMP Settings
NOTE: All functions listed on the Multicast
> IGMP Settings screen require “Enable IGMP
Snooping” to be enabled before settings will
take effect.
Enable IGMP Snoopng Indicates if IGMP Snooping is
enabled on the device.
Enable Unregstered IP Multcast Floodng Indicates
if Unregistered IP Multicast Flooding is enabled on the
device.
VLAN ID Displays the VLAN ID number.
Enable IGMP Snoopng Indicates if IGMP Snooping is
enabled on each VLAN interface.
Enable IGMP Queryng Indicates if IGMP Querying is
enabled on each VLAN interface.
Click Save Settngs to save any changes.
Admin > Ping
You can use a ping to see if another site on the network
can be reached. Ping sends ICMP echo request packets to
another node on the network.
Admin > Ping
•