Linksys SLM2005 - Manual (Page 6)


Product Overview
5-Port and 8-Port 10/100/1000 Ggabt Smart Swtches wth PD and AC Power
Chapter 
Chapter :
Product Overvew
Front Panel
The LEDs are located on the front panel of the Switch.
Front Panel - SLM2008
System (Green) Lights up green to indicate that
power is being supplied to the Switch.
1-5 or 1-8 (Green) Each LED will light up
when there is a connection made through its
corresponding port. It will flash when there is
activity on its corresponding port.
Back Panel
The Ethernet ports are located on the back panel of the
Switch.
Back Panel - SLM2008
Ethernet 1 The Switch’s first RJ-45 port supports
the IEEE 802.3af Power-over-Ethernet (PoE) PD
standard that enables DC power to be supplied
to the Switch using wires in the connecting
twisted-pair cable. Any 802.3af-compliant Power
over Ethernet device attached to the port can
directly supply power to the Switch over the
twisted-pair cable without requiring its own
separate power source.
To connect a device to a port, you will need to
use Category 5e (or better) network cable.
Ethernet 1-5 or 1-8 These RJ-45 ports support
network speeds of either 10Mbps, 100Mbps, or
1000Mbps and can operate in half and full-duplex
modes. Auto-sensing technology enables each
port to automatically detect the speed of the
device connected to it and adjust its speed and
duplex accordingly.
Side Panels
The Reset button and Power port are located on the right
side panel of the Switch.
Right Side Panel
Reset Button The Reset button can be used to
reset or reboot the Switch.
Reboot If the button is pressed for less than
10 seconds, the Switch will reboot.
Restore Factory Defaults If the button
is pressed for longer than 10 seconds, the
Switch’s settings will be restored to the
factory defaults.
•
•
NOTE: The Switch can only be configured using
the web-based utility. If you cannot access the
web-based utility because of configuration
changes you’ve made, you can reset the Switch
to the factory defauts.
Power The Power port is where you will
connect the AC power.
The security slot is located on the left side panel of the
Switch.
Left Side Panel
Securty Slot The security slot can be utilized
to attach a lock to the Switch.