Important safety information, This is a heating appliance – Langley/Empire RH-25-6 User Manual

Page 3

Advertising
background image

Page 3

12821-6-0406

• Due to high temperatures, the room heater should be

located out of traffic and away from furniture and drap-

eries.

• Children and adults should be alerted to the hazards of

high surface temperature and should stay away to avoid

burns or clothing ignition.

• Young children should be carefully supervised when they

are in the same room as the room heater.

• Clothing or other flammable material should not be placed

on or near the room heater.

• Due to high surface temperatures, keep children, clothing

and furniture away.

• Keep burner and control compartment clean.
• Installation and repair should be done by a QUALIFIED

SERVICE PERSON. The room heater should be inspected

before use and at least annually by a qualified service

person. More frequent cleaning may be required due to

excessive lint from carpeting, bedding material, etc. It

is imperative that control compartments, burners and

circulating air passageways of the room heater be kept

clean.

• DO NOT put anything around the heater that will ob-

struct the flow of combustion and ventilation air. See

clearances.

• DO keep the appliance area clear and free from combus-

tible material, gasoline and other flammable vapors and

liquids.

• DO examine venting system periodically. Clean and

replace damaged parts. Examinations should be made

at the start of the heating season and also in mid heating

season under average conditions.

• DO examine burners periodically. Clean and replace

damaged parts.

• DO NOT use this heater if any part has been under water.

Immediately call a qualified service technician to inspect

the heater and to replace any part of the control system

and any gas control which has been under water.

THIS IS A HEATING APPLIANCE

DO NOT OPERATE THIS APPLIANCE WITHOUT FRONT PANEL INSTALLED.

Attention: During operation of vented room heater the gasket for observation hole cover, observation hole cover and cover plate for

observation hole cover must be attached to combustion chamber and secured with two (2) wing nuts.

IMPORTANT SAFETY INFORMATION

Advertising
This manual is related to the following products: