Lindy 32354 - Manual (Page 56)

LINDY CPU Switch Dual Multi-Platform Installation and Use Page 55
when configuring a cascade of LINDY CPU Switches are given in section 2.5.
Although it is theoretically possible to select computers on cascaded units by
pressing the hotkeys and then typing in the port address this would be highly
confusing for users and is not generally recommended. Consequently it is normally
advisable to use the on-screen menu to select computers on cascaded units.
However it is sometimes useful to be able to connect to ports on cascaded units via a
specific cascade cable (rather than the first available of a group) in order to check
that the cabling is working as expected. To do this you can use a hotkey sequence
similar to the example shown below.
For example to connect to port 14 on a LINDY CPU Switch Dual MP that is cascaded
off port 1 of your first LINDY CPU Switch Dual MP. Although the following example
selects a port with a four digit address (port 0114) you can type port addresses that
are eight digits long to access computers that are on the forth cascade level (e.g.
Port 01140203).
press
ba0
release
0
press
1
release
1
press
1
release
1
press
4
release
4ba
4.16 Resetting user port keyboards and mice
The user port keyboards and mice may be reset by disconnecting then reconnecting
the device. You may also disconnect devices and reconnect different devices.