Lowrance electronic 5200C - Manual (Page 140)

134
agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-
chronization.
2. Highlight
B
US
S
ETUP
and press
ENT
, which will open the Bus Configu-
ration menu. A list of network devices will be at the top of the page.
3. Use
↑ ↓ to select the desired engine interface and press
ENT
. The De-
vice Configuration menu will appear.
4. Highlight
E
NGINE
T
YPE
and press
ENT
, which will open the Engine
Type menu with the following options: DF40, DF50, DF60, DF70,
DF90/115, DF140, DF150, DF175, DF200/225, DF250 and DF300.
5. Select your engine type and press
ENT
. The following message will
appear: Are you sure you wish to change this device's configuration?
6. Highlight
Y
ES
and press
ENT
. Press
EXIT
repeatedly to get back to the
main display.
Advanced Options menu
The Engine Interface Advanced Options menu contains three catego-
ries: Instance, Restore Defaults and Reset Trim Calibration.
Instance
The Instance command is intended for use only by experienced NMEA
2000 network technicians. Instance allows network technicians to re-
solve certain electronic probe conflicts. This is most likely to occur if the
network includes LMF-200 or LMF-400 digital gauges, which support
the display of fewer electronic probes than your GPS or sonar/GPS unit.
If you want to use your unit in a network including one of these digital
gauges, you may need to consult customer service. You should never
need this command if you are connecting your unit to a network with
similar display units and/or a series of electronic probes.
Restore Defaults
The Restore Defaults command allows you to reset an individual en-
gine interface's settings to factory defaults. If, for example, you execute
the Restore Defaults command from your Port Engine Interface Ad-
vanced Options menu, only the settings for the Port Engine Interface
will be reset to factory defaults. Other engine interfaces on the network
will not be affected.
To restore default settings:
1. Press
MENU| MENU
, use ↑ ↓ to select
NMEA 2000
and press
ENT
. The
NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-
agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-
chronization.
2. Highlight
B
US
S
ETUP
and press
ENT
.