Land Pride 313-308M - Manual (Page 10)

8
Section 1: Assembly & Set-Up (Standard)
PS2096 Series Primary Seeders 313-308M 6/15/10
Table of Contents
Section 1: Assembly & Set-Up (Standard)
Pre-Assembly Checklist
Check Reference
All major frame components Operator’s
Manual
Fasteners and pins that were shipped
with the seeder.
NOTE: All hardware from the factory
has been installed in the location where
it will be used. If a part or fastener is
temporarily removed for assembly
reasons, remember where it goes.Keep
the parts separated. Operator’s
Manual
All working parts are moving freely,
bolts are tight and cotter pins are
spread. Operator’s
Manual
If a pin, bolt or other part has been
removed, and you are unsure where it
is used, refer to the parts manual. Be
sure the part gets used in the correct
location. By double checking while you
assemble, you will lessen the chance of
using a bolt incorrectly that may be
needed later. Operator’s
Manual
All grease fittings are in place and
lubricated. Section 4
Page 25
Proper tension and alignment on all
drive chains. Operator’s
Manual
Safety decals are correctly located and
legible. Replace if damaged. Important
Safety
Information
Sling Bracket
Refer to Figure 1-1
The sling brackets allow points at each end to hook the
chain for lifting of the unit. When hooking the chain to the
sling brackets, be certain to either use a spreader bar on
the chain or use a long chain to prevent bending the sling
brackets.
Sling Bracket
Figure 1-1
Tire Track Remover Assembly
For shipping purposes the Tire Track Removers are
assembled 180 degrees from their operating position.
Refer to Figure 1-2
1.
Remove Track Remover (#1).
2. Flip Track Remover over 180 degrees and reassemble
as shown with 1/2” u-bolt (#4), lockwasher (#3) and
nut (#2).
Tire Track Remover
Figure 1-2
20589